Our comprehensive online used M45 truck parts recycler catalog was designed with your comfort and convenience as inspiration. Check out our online used M45 part finder store anytime you want, here you can order superior quality used M45 part finder at discount prices. One of the advantages you enjoy is the consistent security of our online used InfinitiM45 truck part locator ordering system. Contact our friendly customer service staff to get reliable and straightforward technical support on your InfinitiM45 junk yard part order. If you want your used M45 part recycler to be delivered to your address quickly and securely, then Quality Used Auto Parts is your store.
Posted: Sat Dec 23, 2006 1:15 pm Post subject: 1995 chev sunfire Engine swap
I am doing an engine swap on a 1995 Pontiac sunfire, does anyone know if I need to pull the engine and tranny as a unit or can I just pull the engine out ?
thanks !!
Dan
Joined: Aug 13, 2006 Posts: 260 Location: nova scotia Canada
Posted: Fri Jan 19, 2007 2:29 pm Post subject:
FUEL PRESSURE RELEASE
1. Loosen fuel tank filler cap to release tank vapor pressure. Raise and support vehicle. Disconnect fuel
pump electrical connector at fuel tank. Start and run engine until engine stops.
2. Engage starter for at least 3 seconds to ensure remaining fuel pressure is released. Disconnect negative
battery cable. Reconnect fuel pump connector. Since some residual pressure may exist in fuel system,
cover fuel line fitting with a shop towel before loosening.ENGINE
Removal & Installation
1. Release fuel system pressure. See FUEL PRESSURE RELEASE under REMOVAL &
INSTALLATION. Drain cooling system. Raise hood fully (disconnect lower end of gas-charged hood
support). Remove air cleaner and intake duct.
2. Disconnect control cables, coolant hoses, vacuum hoses, and electrical connectors as necessary. Remove
engine mount strut. Rotate engine forward on its mounts. Remove power steering pump (leave hoses
connected). Remove bolts securing engine to transaxle (except upper 2 bolts).
3. Rotate engine rearward. Raise and support vehicle. Remove right front wheel. Remove engine splash
shield. Disconnect exhaust pipe. Remove flywheel cover and starter motor. Remove nuts securing engine
mount to frame. Remove bolts securing torque converter to flexplate. Remove A/C compressor (leave
hoses connected).
4. Disconnect front exhaust pipe support bracket at transaxle. Remove bolt that secures transaxle support
bracket to transaxle. Lower vehicle. Rotate engine forward. Remove one of 2 remaining bolts securing
engine to transaxle.
5. Rotate engine rearward. Remove remaining bolt. Attach lifting device. Remove engine. To install, reverse
removal procedure. Tighten nuts and bolts to specification. See TORQUE SPECIFICATIONS . Fill
cooling system.
NOTE: Remove engine through top of engine compartment.
2.2L 4-CYL - VIN [4] 1995 GENERAL MOTORS ENGINES 2.2L 4-Cylinder
good luck
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
Copyright 2002 QAParts.com - All Rights Reserved Used Auto Parts at a price you can afford with service you deserve. View our link partners here. Privacy
Forum FAQ
Search
Usergroups
Profile
Log in to check your private messages
Log in
